Specifications:
Enclosure Type:
Sealed
Driver Type:
10W3v2-D2
Nominal Impedance:
4
Ω
Cont. Power Handling:
300 Watts
JL Audio recommends using a high quality amplifier such as the JL Audio 250/1. The diagram below shows the recommended
crossover, infrasonic filter and equalizer settings for the 250/1 when being used to power your Stealthbox®.
Included Hardware:
1)
3” x 3” Wax Square
1)
3/8-16 x 2-1/4” Socket Cup Set Screw
1)
Mounting Support Plate
1)
3/8” x 1-1/4” Fender Washer
1)
3/8” Flat Washer
1)
3/8” Lock Washer
1)
3/8”-16 Hex Nut
10369 N. Commerce Pkwy, Miramar, Florida 33025-392 Phone: 954.443.1100 Fax: 954.443.1111
JL AUDIO
250/1
monoblock subwoofer amplifier
Amplifier Input Section
Input Sens.
Input Voltage
Low/High
Left Ch.
Right Ch.
Signal Sensing
Off/On
Output Mode
Full-Range/Low-Pass/High-Pass
Left Ch.
Right Ch.
Amp LP Filter
Mode/Slope
Off/12dB/24dB
Filter Freq. (Hz)
Bass Control
LF Boost (dB)
Off/30Hz
Infrasonic Filter
+1
+13
+3
+7
+10
Preamp Output Section
+12VDC
Ground
Remote
The JL Audio 250/1 is a very versatile audio component. Please consult the owner’s manual for detailed information
about installing and tuning this amplifier.
➔
➔
➔
STEP 7: (a)
Run speaker wire form the amplifier’s
location to the Stealthbox’s® terminal and connect.
(b)
Back out the Socket Cup Set Screw to expose
1-1/2”. Place the Stealthbox® into place and guide
the Socket Cup Set Screw through the drilled hole
from
STEP 6
.
STEALTHBOX WALL
THREADED INSERT
FENDER WASHER
VEHICLE SHEET METAL
FLAT WASHER
SOCKET CUP SET SCREW
LOCK WASHER
HEX NUT
MOUNTING SUPPORT PLATE
STEP 8:
Once the Stealthbox® is in place, from
the under side of the car. Place the supplied mount-
ing support plate, fender washer, flat washer, lock
washer and hex nut onto the exposed Socket Cup
Set Screw.
STEP 9:
Thigthen the bolt assembly, do not over
torque.
➔
S B - G M - V E T C 6 / 1 0 W 3 v 2 , J L AU D I O, I n c 2 0 0 5
S h e e t S K U # 0 1 1 1 9 8 R ev i s i o n 1 1 / 1 6 / 2 0 0 5
Pa g e 2
w w w . j l a u d i o . c o m
Mid/High Frequency Driver Information:
CONGRATULATIONS!
INSTALL COMPLETE.
ZR650-CSi
XR525-CXi
Front Location Driver Size:
10”
Applicable JL Audio Products:
TR,VR,XR & ZR650-CSi*
*mounting plate is needed
Rear Location Driver Size):
5.25”
Applicable JL Audio Products:
TR,VR & XR525-CXi
Cont.
From
Previous
Page
Difficulty Of Installation:
