S T e P 9
Driver's side:
Grab the black plastic box(vent columns) and pull it towards
the front of the truck, until it clears the threaded stud(circled).
No mounting hardware secures this vent column to the
truck.
After the vent column is free from the threaded stud,
lift up and pull the vent column out.
The vent that is mounted to the rear wall, needs to stay in
place.
Continued on Next Page
SB-GM-SLVCRW/10W1v2_INSTR_SKU#011173
S T e P 7
With a T-45 socket and ratchet, remove both the passenger’s
side and the driver’s side seat belt retracting units.
S T e P 6
Pop the c-pillars off the wall.
Stretch out the seat belts and carefully place both c-pillars
into the bed of the truck, so they are out of the way.
S T e P 5
Pull off the driver’s side rear door sill plate.
S T e P 4
With a Phillips screw driver, remove the two screws that
secure the driver’s side c-pillar to the rear wall.
S T e P 8
Passenger's side:
Grab the black plastic box(vent column) and pull it towards
the front of the truck, until it clears the threaded stud(circled).
No mounting hardware secures this vent column to the
truck.
After the vent column is free from the threaded stud,
lift up and pull the vent column out.
The vent that is mounted to the rear wall, needs to stay in
place.
Page 2 • JL Audio, Inc 2006
S T e P 1 0
If the truck is not equipped with the folding floor
extensions, go to STeP 13
.
Remove the driver's side and the passenger's side folding
floor extensions from the mounting bar (circled).
Remove the rear wall carpeting.
S T e P 1 1
With cut off wheels or a saw, remove both folding floor
extension mounting bars from the rear seat mounting
supports.
If you are to use cut off wheels, protect the interior from
the sparks. Do not allow the sparks to shower upward. The
sparks will cause cosmetic damage to the headliner.
