SB-GM-C6CONV/8W3v3_INSTR_SKU#011225
SB-GM-C6CONV/8W3v3_INSTR_SKU#011225
5/16-inch FLAT WASHER
5/16-inch SPLIT LOCK WASHER
5/16-inch HEX BOLT
BULKHEAD
5/16-inch COUPLING NUT
PAINTED INTERIOR TRIM PIECE
5/16-inch FLAT WASHER
5/16-inch HEX BOLT
5/16-inch SPLIT LOCK WASHER
5/16-inch FLAT WASHER
5/16-inch FLAT WASHER
C O N G R A T U L A T I O N S
You have completed the installation for this model!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
S T E P 1 4
From the back side of the rear bulkhead, place the last pair of
bolt assemblies through the factory holes.
Place a supplied
5/16-inch
flat washer onto each hex head
bolt, between the painted interior trim piece and in front of
the rear bulk head.
Hand tighten these bolt assemblies to the coupling nut that
is attached to the painted interior trim piece.
S T E P 1 3
Place the painted interior trim piece back into the vehicle.
Mount the painted interior trim piece with the allen screws
that were removed in STEP 3.
S T E P 1 2
Place a supplied 5/16-inch lock washer and then a supplied
5/16-inch flat washer onto each 5/16-inch hex head bolt.
From inside the trim piece, place two of these bolt assemblies
through the holes that are on the back side of the trim piece.
Place a supplied 5/16-inch flat washer onto each exposed
5/16-inch hex head bolt. Hand tighten each supplied coupling
nut onto each 5/16-inch hex head bolt. Look to STEP 14 for
a cross section illustration.
Page 3 • JL Audio, Inc 2006
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU#011225-12-19-200
JLA-SKU#011225-12-19-2006
6
• Printed in USA • ©2005 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902
#6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign
patents pending. For more detailed information please visit us online at
www.jlaudio.com.
(954) 443-1100
w w w . j l a u d i o . c o m
1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A
I N C L U D E D H A R D W A R E
(2)
(2)
3/8-inches -16 x 1-inch Hex Head Bolts
3/8-inches -16 x 1-inch Hex Head Bolts
(2)
(2)
3/8-inch x 1-1/4-inches Fender Washers
3/8-inch x 1-1/4-inches Fender Washers
(4)
(4)
5/16-inch Split Lock Washers
5/16-inch Split Lock Washers
(2)
(2)
3-inches x 3-inches Wax Squares
3-inches x 3-inches Wax Squares
(2)
(2)
3/8-inch Split Lock Washers
3/8-inch Split Lock Washers
(2)
(2)
5/16-inch -18 x 7/8-inch x 9/16-inch Coupling Nuts
5/16-inch -18 x 7/8-inch x 9/16-inch Coupling Nuts
(4)
(4)
3/8-inch x 2-inch Fender Washers
3/8-inch x 2-inch Fender Washers
(4)
(4)
5/16-inch -18 x 1/2-inch Hex Head Bolts
5/16-inch -18 x 1/2-inch Hex Head Bolts
(8)
(8)
5/16-inch Flat Washers
S P E C I F I C A T I O N S
Enclosure Type:
Acoustic Suspension (sealed)
Acoustic Suspension (sealed)
Driver Type:
8W3v3-8
8W3v3-8
Nominal Impedance:
4 ohm mono or 8 ohm stereo
4 ohm mono or 8 ohm stereo
Continuous Power Handling:
300 Watts
300 Watts
P O W E R R E C O M M E N D A T I O N
JL Audio recommends using a high quality amplifier such as the JL Audio 250/1.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 250/1 when
being used to power your Stealthbox
®
.
JL AUDIO
250/1
monoblock subwoofer amplifier
Amplifier Input Section
Input Sens.
Input Voltage
Low/High
Left Ch.
Right Ch.
Signal Sensing
Off/On
Output Mode
Full-Range/Low-Pass/High-Pass
Left Ch.
Right Ch.
Amp LP Filter
Mode/Slope
Off/12dB/24dB
Filter Freq. (Hz)
Bass Control
LF Boost (dB)
Off/30Hz
Infrasonic Filter
+1
+13
+3
+7
+10
Preamp Output Section
+12VDC
Ground
Remote
The JL Audio 250/1 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.
M I D / H I G H F R E Q U E N C Y D R I V E R F I T M E N T
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location:
10-inches / Front Doors
10-inches / Front Doors
*Fits JL Audio Models:
TR650CSi, TR650-CXi, VR650-CSi, VR650-CXi, XR650-CSi, XR650-CXi & ZR650-CSi
TR650-CXi, VR650-CSi, VR650-CXi, XR650-CSi, XR650-CXi & ZR650-CSi
*Speakers require custom adaptors for installation.
Rear Speaker Size / Location:
5.25-inches / Behind Seats
5.25-inches / Behind Seats
*Fits JL Audio Models:
TR525-CXi, VR525-CXi & XR525-CXi
TR525-CXi, VR525-CXi & XR525-CXi
*Installation of Stealthbox
®
prevents installation of rear speakers
