SB-D-DAKCC/10W3v3_INSTR_SKU#011223
SB-D-DAKCC/10W3v3_INSTR_SKU#011223
C O N G R A T U L A T I O N S
You have completed the installation for this model!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
S T E P 1 4
Using a
9/16-inch socket and socket wrench or an open end
wrench, secure each bolt assembly.
S T E P 1 3
With a bolt assembly in hand, reach behind the side
bulkhead opening revealed in
Step 12
. Guide the bolt
assembly up and through the driver’s side mounting hole
made in
Step 8
. Thread it through two of the supplied
spacers into the Stealthbox
®
and tighten by hand.
S T E P 1 2
Remove the driver’s side rear sill plate and pull up the
carpeting to expose the bulkhead, as seen in the picture.
Page 3 • JL Audio, Inc 2006
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU#011223-11-10-200
JLA-SKU#011223-11-10-2006
6
• Printed in USA • ©2005 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902
#6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign
patents pending. For more detailed information please visit us online at
www.jlaudio.com.
(954) 443-1100
w w w . j l a u d i o . c o m
1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A
I N C L U D E D H A R D W A R E
(2)
(2)
3/8-inch Split Lock Washer
3/8-inch Split Lock Washer
(2)
(2)
3-inch x 3-inch Wax Squares
3-inch x 3-inch Wax Squares
(2)
(2)
3/8-inch Flat Washer
3/8-inch Flat Washer
(2)
(2)
3/8-inch - 16 x 3-1/2-inch Hex Head Bolts
3/8-inch - 16 x 3-1/2-inch Hex Head Bolts
(4)
(4)
1-inch Outer Diameter x 1-inch Height - 3/8-inch Inner Diameter Spacers
1-inch Outer Diameter x 1-inch Height - 3/8-inch Inner Diameter Spacers
S P E C I F I C A T I O N S
Enclosure Type:
Acoustic Suspension (sealed)
Acoustic Suspension (sealed)
Driver Type:
10W3v2-D2
10W3v2-D2
Nominal Impedance:
4 ohms mono
4 ohms mono
Continuous Power Handling:
300 Watts
300 Watts
P O W E R R E C O M M E N D A T I O N
JL Audio recommends using a high quality amplifier such as the JL Audio 250/1.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 250/1 when
being used to power your Stealthbox
®
.
JL AUDIO
250/1
monoblock subwoofer amplifier
Amplifier Input Section
Input Sens.
Input Voltage
Low/High
Left Ch.
Right Ch.
Signal Sensing
Off/On
Output Mode
Full-Range/Low-Pass/High-Pass
Left Ch.
Right Ch.
Amp LP Filter
Mode/Slope
Off/12dB/24dB
Filter Freq. (Hz)
Bass Control
LF Boost (dB)
Off/30Hz
Infrasonic Filter
+1
+13
+3
+7
+10
Preamp Output Section
+12VDC
Ground
Remote
The JL Audio 250/1 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.
M I D / H I G H F R E Q U E N C Y D R I V E R F I T M E N T
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location:
6.5-inch / Front Doors
6.5-inch / Front Doors
Fits JL Audio Models:
TR650-CXi, VR650-CSi, VR650-CXi, XR650-CSi, XR650-CXi & ZR650-CSi
TR650-CXi, VR650-CSi, VR650-CXi, XR650-CSi, XR650-CXi & ZR650-CSi
Rear Speaker Size / Location:
6.5-inch / Rear Doors
6.5-inch / Rear Doors
Fits JL Audio Models:
TR5650-CXi, VR650-CXi & XR650-CXi
TR5650-CXi, VR650-CXi & XR650-CXi
