➔
➔
➔
➔
➔
STEP 10:
Install #8 x 1/2” black pan-head screws
into the drilled holes.
Cont..
From
Previous
Page
Continued on Next Page
➔
➔
STEP 11:
Using a 1/8” drill bit and drill. Drill two
holes at the hinge area using the outside holes only.
The center hole does not need to be drilled.
➔
STEP 12:
Remove the screws installed in
STEP 8
and
STEP 10
. Separate the console shell from the
Stealthbox.
STEP 13:
Attach the OEM’s console lid to the
shell. Use one of the OEM’s screws and supplied
speed-clip to the center hole of the hinge.
STEP 9:
Turn the console right-side-up with the
Stealthbox attached.
Using the holes on the top of the console shell as
guides, use a 1/8” drill bit and drill to drill holes
through each of these guide holes and into the
Stealthbox.
S B - F - S U P R C N S L / 1 0 W 3 V 2 , J L AU D I O, I n c 2 0 0 5
S h e e t S K U # 0 1 1 1 4 9 R ev i s i o n 8 / 4 / 2 0 0 5
Pa g e 2
w w w . j l a u d i o . c o m
STEP 14:
Place the Stealthbox in the vehicle. Using
a pair of OEM bolts, from
STEP 1
. Loosely secure
the rear foot bracket to the floor, do not tighten.
STEP 15:
Remove the paper backing on the sup-
plied sheet wax squares.
With the Stealthbox in place, lift the front of the
Stealthbox and position both supplied sheet wax
squares onto the carpet and lined up with the front
foot bracket of the Stealthbox, lower the console
down.
STEP 16:
Using one of the supplied 3/8”x1-1/2”
bolts, place the bolt through each hole of the front
foot bracket (one at a time). Press down on the bolt,
too leave impressions on the sheet wax squares.
STEP 17:
Remove the two OEM bolts from
STEP
14
. Remove the Stealthbox from the vehicle.
