4
| JL Audio - MX650-CCX-SG (LED) Owner’s Manual
BEFORE YOU BEGIN INSTALLING
• Check with your local waterway authority
for any regulations regarding the use of
accent/speaker lighting on your vessel.
• Turn off the audio system. It is also advisable
to disconnect your battery system whenever
performing installation work.
• Before cutting, drilling or inserting any screw,
check clearances on both sides of the planned
mounting surface. Also check for any potential
obstacles, such as wiring harnesses, fuel lines,
hydraulic lines, etc. Check both sides of the
vessel before cutting any holes.
• If you are running cables through bulkheads,
drill holes for the cable and use a urethane
or plastic grommet to protect the wire from
chafing in the hole. Make sure that the cables
will clear any mechanical devices in the boat
and secure them with wire ties.
• Wear protective eyewear at all times and a dust
mask and gloves when drilling or cutting.
If you have any questions about the installation
or setup of your coaxial speaker system not
covered in this manual, please contact your
dealer or technical support.
JL Audio Technical Support:
(954) 443-1100
9:00 AM – 5:30 PM (Eastern Time Zone)
Monday - Friday
TWEETER PROTECTION
The crossover networks are equipped with
an advanced electronic tweeter protection circuit
designed to minimize the possibility of tweeter
failure. This electronic device monitors current going
to the tweeter and will disconnect the tweeter from
the signal when it senses overload. Should this occur
while listening to the audio system, simply reduce the
volume for a few seconds and the protection circuit
will reset itself automatically.
INTERCHANGEABLE LOGO BADGE
Interchangeable Logo Badges for Sport
Grille model coaxial speakers are included to
further customize your installation. The design
of the Sport Grille allows for the JL Audio logo
to be added in your choice of included colors and
oriented in the manner that best suits
your installation.
NOTE: A left and a right badge of each
color is included. These two different
orientations ensure the “JL Audio” Logo will
read correctly wherever positioned (most
commonly the 3:00 or 9:00 position).
Remove the adhesive backing from the badge
and affix the badge to the grille using the small
positioning hole as a guide. See diagram below.
3:00 Position
9:00 Position