6
JL Audio
TURN-ON LEAD
The JX360/2 is turned on and off
VTJOHBDPOWFOUJPOBM7SFNPUFUVSO
on lead, typically controlled by the
source unit’s remote turn-on output.
+12 VDC
Ground
Remote
5IFBNQMJGJFSXJMMUVSOPOXIFO7JT
present at its “
Remote
” input and turn off when
7JTTXJUDIFEPGG*GBTPVSDFVOJUEPFTOPU
have a dedicated remote turn-on output, the
BNQMJGJFSTUVSOPOMFBEDBOCFDPOOFDUFEUP7
via a switch that derives power from an ignition-
switched circuit.
18 AWG wire is more than adequate for the
remote turn-on connection. To connect the
remote turn-on wire to the amplifier, strip 1/2-
inch (12 mm) of insulation from the wire and
insert it into the “Remote” receptacle on the
power connector. Tighten the connector down
using the supplied 2.5 mm hex wrench.
INPUT SECTIONS
The JX360/2’s has one pair of stereo
inputs.The input section input section
offers two input connection methods, one
for high-level (speaker level) signals and
one for low-level (preamp level) signals.
1) Low-Level Inputs:
A standard left/
right pair of RCA type jacks in the
“Amplifier Inputs”
section is used for
preamp level (low-level) signal input
on the JX360/2. This is the preferred
connection method whenever available.
