Page 5 • JL Audio, Inc., 2017
Continued on Next Page
S T E P 16
Replace the jack tools, if desired, and fold the
rear seats back down.
S T E P 15
Slide a 1/4” Split Lock Washer and a 1/4” Flat
Washer over a 1/4 - 20 x 1” Hex Bolt, pass the
assembly through the slot in a Short Bracket,
into a threaded insert on the front of the
enclosure, and fully tighten.
Repeat the process for the opposite side.
S T E P 14
Align the slot in each of the Long Brackets with
the threaded studs, as shown. Add a factory
nut over each threaded stud, and fully tighten.
S T E P 13
Connect speaker cable to the terminal cup
on the side of the enclosure, and place the
Stealthbox into position, as shown. Route the
speaker cable as necessary.
S T E P 12
Note the location of the threaded studs in the
back of the vehicle. Push the carpet down,
leaving the threaded studs exposed.
S T E P 11
Slide a 1/4” Split Lock Washer and a 1/4” Flat
Washer over a 1/4 - 20 x 1” Hex Bolt, and pass
the assembly through the short end of a Long
Bracket, and into a threaded insert on the back
of the enclosure.
Align the Long Bracket as shown, and fully
tighten.
Repeat the process for the opposite side.
S T E P 10
Fold the carpet up, reinstall the Short Bracket
and Torx bolt, and fully tighten.
Repeat
Steps 8-10
for the opposite side.
S T E P 9
Remove the Short Bracket and Torx bolt.
Carefully cut a slit in the carpet on each of the
marks made in the previous step to allow the
carpet to fold up.
SB-GM-COCREW2G/10TW3 INSTR_SKU# 011474
