2112K
JKS Flex Connect Installation
Page 2
WARNING
Higher Rollover Risk
Modifying your Jeep® to improve off-road perfor-
mance may result in vehicle handling different than as
factory equipped, including increased ride-height and/
or chassis articulation; reduced lateral stability and
higher risk of roll-over or other accident. Also, owner’s
choice of larger tire and wheel combinations may
require additional braking force or increased stopping
distances.
To reduce risk of serious injury and accident:
Â
Choose modifications that balance your actual
highway & off-road use.
Â
Avoid sharp turns, abrupt maneuvers or steep
side-cambers.
Â
Avoid other maneuvering conditions which may
cause the vehicle to trip, roll, lose traction or com-
promise your ability to safely brake in an emer-
gency.
Â
Routinely inspect your vehicle components for un-
usual wear or off-road damage. Repair or Replace
any unserviceable components before use.
Â
Acquaint any other drivers with your vehicle modi-
fications and handling.
Â
Always wear seat belts and/or appropriate off-road
restraints, reduce your speed, Tread Lightly©.
Important
Designed for use the factory sway bar. Fitment and
performance with aftermarket sway bars is up to the
installer.
Flex Connect Link Measures 9-3/4" eye-eye. Can be
installed on other applications. Fitment is up to the
installer. If the links being replaced measure longer
than 9-3/4" eye-eye, additional modifications may
be required to avoid sway bar inversion in full droop
conditions. Check link position at full suspension
droop before driving. Contact JKS tech support for
additional assistance if this condition exists.
Some vehicles may require extended front brake
hoses or other modifications to compensate for ad
-
ditional suspension travel.
Installation
1. REMOVE ORIGINAL EQUIPMENT (OE)
SWAYBAR LINKS
Disconnect the sway bar links from both sides of
vehicle at the axle first (15mm & 18mm).
After both links are disconnected from the axle,
pull down on the sway bar to gain access to the
bolts to disconnect the sway bar links from the
sway bar (18mm). If links are after market, mea
-
sure eye-eye length. If they are longer than 9-3/4",
see "Important Notes". Discard links and Hard
-
ware