JK Audio RIU-IP, User Manual

Page: 6 / 20

2
RIU-IP
Remote IP Interface
Setup
1. Connect the 10-conductor interface cable (supplied) from the RJ-50 <Remote
Port> on the RIU-IP to the <Remote> jack on the back of your JK Audio
innkeeper 1x/1rx or innkeeper 2/4. Power will be supplied to the device
through this cable so no other power source is necessary.
Note: Each time the unit is powered up it will need at least 30 seconds to complete its boot-up
sequence before you can access the web browser.
There are no jumpers, switches or other user configurable options on this device. The red
LED on the circuit board only shows that the unit is receiving power through the Remote Port
connection and will not indicate when the unit is sending or receiving commands.
2. Connect a standard Ethernet cable from the RJ-45 <IP/Ethernet> port on the
RIU-IP to your network card. The IP address for this device will be assigned
initially as 192.168.1.222.
Note:
Every network is different. Please contact you network administrator for setup assistance
if necessary. After the RIU-IP has been installed, your Network Administrator will be able to
determine the current RIU-IP address if the initial static IP address does not appear valid.