JR Flexo Press Series
13
And then clean the anilox roller, the ink duct, the plate wheel and finally the whole
machine.
III. Trial running and switch on and off machine
Switch on the power source.
1. When there is no material to block the photoelectric probe, use material to block the
photoelectric switch; otherwise, the machine is unable to start.
2. Check the counter to see if it is in the position of “zero”. When the number reaches the
preset number and the “zero” is not pressed, the machine will stop automatically.
3. When the machine is trial running without load, all the inkless ducts should be taken
down and put aside. Check every part and see if they are running normally, especially
the rotating direction of the anilox roller. Whatever types of the machine, the correct
rotating direction of the anilox roller should rotate towards its matched ink duct. If the
rotating direction is not correct, ask the electrician to change the rotating direction of
the motor. When everything is confirmed normal, enter the next step.
4. Press the yellow “spot move” knob on the main control box, and the machine will be in
the position of spot movement.
5. Press the green “operation” knob on the main control box and adjust the “printing
speed” knob to let the machine run at low speed. If everything is normal, continue the
following adjustment.
6. Press the red “OFF’ knob on the main control box, and the machine stops running.
When the machine is in operation, press the yellow “spot move” knob or the yellow
“spot move” knob on the main wall board of the 6/2 type and the 3/1 type, the machine
can also stop running.
7. put on the ink ducts (according to the actual use, if there is an empty color position or
positions, there is no need to put on the ink ducts), drop a moderate amount of
lubricating oil into the anti-overflow hole in the combination of the ear plate of the ink
duct and the anilox roller. Add a proper amount of ink in the ink duct; adjust evenly the
adjusting bolt of ink until the amount of ink on the anilox roller meets the requirement.
(slow speed while adjusting)