2013
6
7
FP3-14-GB(V3)
www.jilong.com
FP3-14-GB(V3 )
www.jilong.com
Item No.
Description
QTY
P1
Air purge cover
1
P2
Air purge cover seal
1
P3
Filter chamber cover retainer
1
P4
Filter chamber cover
1
P5
Filter chamber rubber gasket
1
P6
Filter cartridge
1
P7
Filter chamber
1
P9
Power cable
1
P10
O ring
2
P11
Hose Clamp
4
P12
Connector Hose
2
P13
Filter Net(Only for 300&530gal)
2
P14
Connector(Only for 300&530gal)
2
Installation Instructions
Please see the diagram of Page 6 & Page 7 for reference.
1. Before start to install filter pump, make sure to set up the pool and fill the water firstly,
following the pool’s installation instructions step by step. Operate the filter pump only
when the water has reached the maximum level in the pool. Low water pressure in the
pump may result in noisy motor sound.
2. Remove the filter pump and hoses from the packaging.
3. Place the Filter Pump below pool water at least 0,2 m and shall not over 1,0 m.
4. Please Note: The filter pump needs to be mounted on a solid and even ground.
There are mounting holes located in the pump base and you can mount the pump with
screws.
5. Put the Filter Cartridge (P6) into the Filter chamber (P7) and make sure the Filter
Cartridge (P6) is inside of the Filter chamber (P7).
6. Put Filter Housing O-Ring (P5) on Filter chamber (P7).
7. Put Filter Housing Cover (P3) on Filter chamber (P7).
8. Then finger tighten the Filter chamber cover retainer (P3) in a clockwise motion.
9. Gently turn the air release valve (P1) in a counter-clockwise direction 1-2 turns.
10. Connect one Filter Hose (P12) to the inlet port of the Filter Pump (top) and the lower
hose connection of the pool. Fix the hose with the hose clamps (P11).
11. Connect the 2nd Filter Hose (P12) to the upper hose connection of the pool and the
outlet port (bottom) of the Filter Pump (see page 7). Fix the hose with the hose clamps.
12. The sound pressure level is less than 82 dB (A).
INST
ALLA
TION ILLUSTRA
TION
ILLUSTRA
TION NOT
T
O SCALE
