background image

ETM1-14-GB

www.jilong.com

2

3

ETM1-14-GB

www.jilong.com

2014

Thank you for purchasing our product and wish you will enjoy it.

The trolling motors are designed and developed by professional engineering teams. With years of 

efforts. The power of trolling motor has widely covered from 30LBS to 86LBS in order to fit various 

costumers’requirements and provide different experiences.

Please read and retain this manual before using this electrical motor. The manual contains information 

that describes the procedure for safe operation and daily maintenance of your trolling motor. Safe 

operation will prevent from personal injury and product damage.

BATTERY CONNECTION METHOD

Before connecting the motor’s cables to the battery terminals, ensure all switches are in the OFF 

position and stand clear of the propeller. Connect the red cable to the positive (+) terminal and the 

black cable to the negative (-) terminal, making sure the terminals are clean before doing so. A clean 

connection will minimize power wastage and give you maximum power from the battery. (A)

The battery should be kept in a well-ventilated location. We recommend using a special deep cycle 

marine battery for optimum performance.

ATTACHING THE MOTOR TO YOUR BOAT

Attach the motor to the stern of the boat and tighten both mounting bolts securely while taking care 

not to over-tighten.

To adjust the angle of the motor after attachment, hold the motor head with one hand and depress the

positioning pin at the top of the mounting bracket with your other hand.

Press and hold the positioning pin until the desired angle has been reached next release the pin and 

ensure the mechanism locks securely. (B)

DEPTH ADJUSTMENT

Hold the motor shaft with one hand, loosen the depth adjustment screw and set the motor to the 

desired depth, then retighten the adjusting screw securely. (C)

(A)

(C)

(B)

Battery Type

Recommended battery(s): 12-volt Deep Cycle battery or Marine battery (24-volts for 86lbs), battery 

should has at least 50-ampere hour rating or higher. To extend running time an additional battery can 

be used. See section on battery connection method.

Cable Size

If extending the standard battery cable supplied with the product, we recommends the use of 13mm2 

wire (6-gauge wire, AWG).

Do not allow children to operate the trolling motor.

Do not modify the unit in any way or add accessories not intended for this product.

Never fully submerse the unit, if unit is accidentally submersed disconnect battery and leave to dry.

Warning:

Be sure switch are in the OFF position before connecting to battery or batteries.

Electrical arcing near the battery could ignite hydrogen gas and cause the battery to explode.

Warning: Before the installation, Make sure the area between column and bracket is clear.

Warning: The motor can only be used

in water deeper than 0.8m.

Warning: Always disconnect power from the motor when replacing propeller, removing debris

around the prop, charging batteries, transporting boat or when the motor is not in use.

Thrust (lbs.)

Voltage (V)

Power (W)

Speed

30

12

312

For5/Re23

 

GENERAL INFORMATION

 

FIRST TIME RUNNING

Basic parameters

WIRING AND BATTERY RECOMMENDATION

SAFETY INFORMATION

Reviews: