Jidé s.a. – Rue des Meuneries 11 – B-4650 HERVE (Belgique) – Tél. +32 87 31.75.12 – Fax +32 87 31.75.11 –
PURE (EN) June 2018
6
Additional parts
– Identification plate
In addition to the fireplace, the packaging contains the following elements:
-
A poker;
-
A cold handle;
-
A glove;
-
A speed controller to regulate ventilation (for fireplaces with ventilation);
-
A short stainless steel duct 45° right-angled for the smoke link;
-
A plate and a fixing screw (to fill the air inlet on the back in case of connection from
the bottom);
-
A paint spray for eventual retouching. Attention: before using the fireplace, make
sure to get the spray out and to keep it away with a minimum distance of 2 m.
-
On the packaging, instructions for use with identification plate.
All the Jidé fireplaces are registered as soon as they leave production, according to the
information contained on a plaque that accompanies this notice, stating in particular the
power, efficiency and CO emissions of the appliance.
This plaque must be kept and will enable your appliance to be identified in our files
(traceability) if necessary. We advise you to paste it on this user and installation notice or on
your invoice.
USER NOTICE
Starting a fire
Before lighting, remove ashes especially on the stainless steel canals.
Do not exceed the maximum loading authorized (see page 10).
IMPORTANT actions before starting your fire:
1
For the correct use of the appliance, the door must be opened slightly for 15 minutes -
the time necessary to reach a sufficient temperature in the fireplace.
2
When the window is hot, please close the door. Combustion air inlet is regulated by the
automatic thermostat to obtain reduced wood consumption with respect to the heat
recovered. When the fireplace is hot, fans start automatically. For devices with manual
thermostat, you have to reduce the air inlet according to the wished heat.
