JGC RRMP-4600, User Manual

Page: 20 / 32

CAUTION:
Usage of controls, adjustments, performance or
procedures other than those specified herein may
result in hazardous radiation exposure. This unit
should not be adjusted or repaired by anyone
except a qualified service person.
INSTALLATION
Unpack all parts and remove protective material.
Do not connect the unit to the power outlet
before checking the voltage and before all other
connections have been made. Do not cover
any vents and make sure that there is a space of
several inches/centimeters around the unit for
ventilation.
INSERT BATTERIES (not included):
Open the battery compartment and insert six (6)
batteries, type Baby (UM-2, C-Cell), preferably
Alkaline, with the correct polarity as indicated by
the „+“ and „-“ symbols inside the compartment.
Batteries contain chemical substances, so they
should be disposed of properly.
Incorrect use of batteries can cause electrolyte
leakage and will corrode the compartment or
cause the batteries to burst. Therefore:
•
Do not mix battery types: e.g. alkaline with
carbon zinc. Only use batteries of the same
type for the set.
• When inserting new batteries, do not try to mix
old batteries with the new ones.
•
Remove the batteries if the set is not to be
used for a long time.
Whenever convenient, use the power supply if
you want to conserve battery life. Make sure you
remove the plug from the set and wall outlet
before inserting batteries.
Using AC Power
1. Check if the power voltage, as shown on the
type plate located on the bottom of the set
corresponds to your local AC power supply. If
it does not, consult your dealer or service
centre.
2. Connect the power cord to the AC MAINS inlet
and the wall outlet. The power supply is now
connected and ready for use.
3. To switch off completely, unplug the power
cord from the wall outlet.
Unplug the power cord from the wall outlet to
protect your set during heavy thunderstorms.
OVERVIEW
20
ENGLISH