ENGLISH
30
CLOCK FUNCTIONS
Operating the radio
• Slide the
FUNCTION
switch (22) on the device to
AM
or
FM
. If the function switch is in the
AM
position, the
device is operating in the AM radio range. If the function switch is in the
FM
position, the device is operating
in the FM radio range.
• Select the desired radio station by means of the
TUNING
control (27).
• The LED indicator
FMST.
(C) will come on, if you are receiving a FM stereo station. Only FM stations are
broadcast in stereo.
Setting the time
• After you have connected the power plug (25) to a power outlet, the time
12:00
will blink in the display (7).
• Hold the
CLOCK/ADJ.
button (18) down for 2 seconds. Either
24 H
or
12 H
will be shown in the display. To
change the time configuration, hold the
CLOCK/ADJ.
button (18) down again for 2 seconds. If you choose
the 24-hour time format, the time of
0.00
will blink in the display panel. For the 12-hour time format, the
time
12:00
will blink in the display.
• Press the
/MINUTE
button (12) to set the minutes and the
/HOUR
button (11) to set the hours.
Confirm by pressing the
CLOCK/ADJ.
button.
• If you select the 12-hour display, the LED indicator
PM
(D) will also be displayed for times after noon.
• If you would like to reset the time again later, press briefly on the
CLOCK/ADJ.
button. The time will blink in
the display. Set the time by means of the
/MINUTE
and
/HOUR
buttons and confirm by pressing the
CLOCK/ADJ.
button.
The time will not be saved, if you pull the plug (25) and if there are no batteries in the battery
compartment (24) on the back of the device. In that event, set the new time again.
Setting the alarm
• You can set a time to wake up at which the device will come on either in the radio or CD mode. Or you can
be awakened by an alarm signal. You can save two wake-up times in total.
• Press the
ALARM1
(15) or the
ALARM2
(14) button. The time digits will blink in the display.
• Set the wake up time with the
/MINUTE
(12) and
/HOUR
(11) buttons and confirm it by pressing
either the
ALARM1
or
ALARM2
button.
• The LED indicator
AL.1
(J) or
AL.2
(I) will light up. If you have saved 2 wake up times, both LED indicators
will come on.
• Set the desired volume by turning the volume control (23) on the device.
• Set the
FUNCTION
switch (22) to
CD
, if you would like to be awakened by music from a CD. Make sure that
there is a CD in the CD compartment (1).
• Set the
FUNCTION
switch to
AM
or
FM
, if you would like to be awakened by the radio. Select the desired
radio station by means of the
TUNING
control (27).
• Set the
FUNCTION
switch to
BUZZER/AUX IN
in order to be awakened by an alarm signal.
JGC-URCD-20-IM-DE-EN-V1.indb 30
29/01/2010 5:26 PM
