Page 39
A-10 Thunderbolt II
1. press magnet into depron to impress shape. 2. Dig out a recess for the magnet
using a sharp knife.
3. Apply glue into recess and
push magnet into it.
5. When fully cured, remove tape
and put adjoining magnet on top
6. When correctly aligned, press adjoining
depron onto the sticking up magnet to impress
shape.
7. Repeat steps 2-4 for the upper part.
Rare-earth Magnet
4. Whilst still wet, lay masking tape
over the area.
IMPORTANT.
Before glueing the upper magnet in,
check that the magnet is the right
way around!
depron spacer
3mm lite ply
tongue
Magnets
3D
Printed
Part
3D
Printed
Part
(optional)
All versions
attachment process
Create the canopy in the same way as the nosecone, or 3d Print
one, and add a tongue and magnets as shown.
