14
(5) LAN Port connector: LAN
This connector is standard RJ45 connector for Network
(6) Parallel Port connector (25-pin D-sub connector): PARALLEL
(7) Serial Port connector: COM1
The connectors is 9-pin Male connector that connect serial devices to the system board.
(8) Audio Connector: CN1
This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC.
Line-out :
Audio output to speaker
Line-in :
Audio input to sound chip
MIC :
Microphone
Connector
(9) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the single
plug end to motherboard, connect the two plugs at other end to the floppy drives.
Floppy Drive Connector
Pin 1
FDD
(10) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the single
plug end to motherboard, connect the two plugs at other end to your hard disk(s). If you
install two hard disks, you must configure the second drive to Slave mode by setting its
jumpers accordingly. Please refer to the documentation of your hard disk for the jumper
settings.
LAN
LINE-OUT
LINE-IN
COM1 USB1
MIC
PS/2 Mouse
PS/2 Keyboard
USB
