7
1.
Check motherboard jumper setting
2.
Install CPU and Fan
3.
Install System Memory (DIMM)
4.
Install Expansion cards
5.
Connect IDE and Floppy cables, Front Panel /Back Panel cable
6.
Connect ATX Power cable
7.
Power-On and Load Standard Default
8.
Reboot
9.
Install Operating System
10.
Install Driver and Utility
2-2
Checking Motherboard’s Jumper Setting
(1) CMOS RAM Clear (3-pin) : JBAT
A battery must be used to retain the motherboard configuration in CMOS RAM short 1-2
pins of JBAT to store the CMOS data.
To clear the CMOS, follow the procedure below:
1.
Turn off the system and unplug the AC power
2.
Remove ATX power cable from ATX power connector
3.
Locate JBAT and short pins 2-3 for a few seconds
4.
Return JBAT to its normal setting by shorting pins 1-2
5.
Connect ATX power cable back to ATX power connector
Note: When should clear CMOS
1.
Troubleshooting
2.
Forget password
3.
After over clocking system boot fail
CMOS RAM Clear Setting
2-3 closed Clear CMOS
JBAT
1
3
JBAT
1
3
1-2 closed Normal
(2) Keyboard Power On function Enabled/Disabled: JP1
When setting Enabled you can using keyboard by key in password to power on system.
