33
Use this item to enable or disable serial port (COM).
Change Settings
Use this item to select an optimal setting for super IO device.
Changing setting
may conflict with system resources.
WatchDog Reset Timer
Use this item to enable or disable WDT reset function.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
WatchDog Reset Timer Value
User can set a value in the range of [4] to [255].
WatchDog Reset Timer Unit
The optional settings are: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power
supply. Use needs to select AT or ATX Mode on MB jumper at first (refer to
Page
11
,
Pin (1-2) of AT_COPEN
jumper for ATX Mode / AT Mode Select).
Case Open Detect
Use this item to detect case has already open or not, show message in POST.
When set as [Enabled], system will detect if COPEN has been short or not (refer to
Page 11); if
Pin (3-4) of AT_COPEN
is short, system will show Case Open
Message during POST.
PC Health Status
Press [Enter] to view current hardware health status, set shutdown temperature, or
make further settings in ‘
SmartFAN Configuration
’.
SmartFAN Configuration
Press [Enter] to make settings for ‘
SmartFAN Configuration
’:
Super IO Configuration
CPUFAN Smart Mode
The optional settings: [Disabled]; [Enabled].
