35
Serial Port FIFO Mode
The optional settings are: [16-Byte FIFO]; [32-Byte FIFO]; [64-Byte FIFO];
[128-Byte FIFO].
►
Serial Port 2 Configuration/ Serial Port 3 Configuration/Serial Port 4
Configuration/ Serial Port 5 Configuration/ Serial Port 6 Configuration
Press [Enter] to make settings for the following sub-items:
Serial Port
Use this item to enable or disable serial port (COM).
Change Settings
Use this item to select an optimal setting for super IO device.
Serial Port FIFO Mode
The optional settings are: [16-Byte FIFO]; [32-Byte FIFO]; [64-Byte FIFO];
[128-Byte FIFO].
WatchDog Reset Timer
Use this item to enable or disable WDT reset function.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
WatchDog Reset Timer Value
User can set a value in the range of [4] to [255].
WatchDog Reset Timer Unit
The optional settings are: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power
supply. Use needs to select AT or ATX Mode on MB jumper at first (refer to
Page
11
, Pin(1-2) of AT_COPEN jumper for ATX Mode / AT Mode Select).
Case Open Detect
Use this item to detect case has already open or not, show message in POST.
4
PC Health Status
Press [Enter] to view current hardware health status, set shutdown temperature, or
Summary of Contents for NF632E Series
Page 9: ...4 Motherboard Internal Diagram Front Side...
Page 11: ...6 Jumper Positions...
