28
This item support Emulate AT power function, MB power On/Off control by power
supply. Use needs to select ‘AT or ATX Mode’ on MB jumper at first (refer to
Page- 9
,
JAT_ATX
jumper for ATX Mode & AT Mode Select).
Case Open Detect
Use this item to detect case has already open or not, show message in POST.
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], system will detect if COPEN has been short or not (refer to
Page-10
,
COPEN
jumper for Case Open Detection); if Pin 1&2 of
COPEN
is short,
system will show Case Open Message during POST.
PC Health Status
Press [Enter] to view current hardware health status, make further settings in
‘
SmartFAN Configuration
’ and set value in ‘
Shutdown Temperature
’.
►
SmartFAN Configuration
Press [Enter] to make settings for ‘
SmartFan Configuration
’:
SmartFAN Configuration
CPUFAN / SYSFAN1/ SYSFAN2 Smart Mode
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
CPUFAN / SYSFAN1/ SYSFAN2 Full-Speed Temperature
Use this item to set CPUFAN/SYSFAN1/SYSFAN2 full speed temperature. Fan
will run at full speed when above this pre-set temperature.
CPUFAN / SYSFAN1/ SYSFAN2 Full-Speed Duty
Use this item to set CPUFAN/SYSFAN1/SYSFAN2 full-speed duty. Fan will run at
full speed when above this pre-set duty.
CPUFAN / SYSFAN1/ SYSFAN2 Idle-Speed Temperature
Use this item to set CPUFAN/SYSFAN1/SYSFAN2 idle speed temperature. Fan
will run at idle speed when below this pre-set temperature.
CPUFAN / SYSFAN1/ SYSFAN2 Idle-Speed Duty
Use this item to set CPUFAN/SYSFAN1/SYSFAN2 idle speed duty. Fan will run at
idle speed when below this pre-set duty.
Shutdown Temperature
Use this item to select system shutdown temperature.
The optional settings are: [Disabled]; [70
o
C/158
o
F]; [75
o
C/167
o
F]; [80
o
C/176
o
F];
[85
o
C/185
o
F]; [90
o
C/194
o
F].
►
Second Super IO Configuration
Second Super IO Configuration
►
Serial Port 7 Configuration/Serial Port 8 Configuration/Serial Port 9
Configuration/Serial Port 10 Configuration
Press [Enter] to make settings for the following sub-items:
Serial Port
Use this item to enable or disable serial port (COM).
Change Settings
Use this item to select an optimal setting for super IO device. Changing setting
may conflict with system resources.
Serial Port Console Redirection