44
*This item may or may not show up, depending on different configuration.
Stop Bits EMS
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
►
USB Configuration
Press [Enter] to make settings for the following sub-items:
USB Configuration
XHCI Hand-off
This is a workaround for OSes without XHCI hand-off support. The XHCI ownership
change should be claimed by XHCI driver.
The optional settings: [Enabled]; [Disabled].
USB Mass Storage Driver Support
Use this item to enable or disable USB Mass storage driver support
The optional settings: [Disabled]; [Enabled].
Port 60/64 Emulation
Use this item to enables I/O port 60h/64h emulation support. This should be enabled
for the complete USB keyboard legacy support for non-USB aware OSes
The optional settings: [Disabled]; [Enabled].
USB hardware delay and time-out
USB Transfer time-out
Use this item to set the time-out value for control, bulk, and interrupt transfers.
The optional settings: [1 sec]; [5 sec]; [10 sec]; [20 sec].
Device reset time-out
Use this item to set USB mass storage device start unit command time-out.
The optional settings: [10 sec]; [20 sec]; [30 sec]; [40 sec].
Device power-up delay
Use this item to set maximum time the device will take before it properly reports itself
to the host controller. ‘Auto’ uses default value: for a root port it is 100 ms, for a hub
port the delay is taken from hub descriptor.
The optional settings: [Auto]; [Manual].
Select
[Manual]
you can set value for the following sub-item: ‘
Device power-up
delay in seconds
’
,
the delay range in from 1 to 40 seconds, in one second
increments.