31
Use this item to select an optimal settings for Super IO Device.
Use this item to select an optimal setting for super IO device.
The optional settings are: [Auto]; [IO=3F8h; IRQ=4]; [IO=2F8h; IRQ=3]; [IO=3E8h;
IRQ=4]; [IO=2E8h; IRQ=3] for
‘
Serial Port 2 Configuration
’.
Transmission Mode Select
The optional settings are: [RS422]; [RS232]; [RS485].
Mode Speed Select
The optional settings are: [RS232/RS422/RS485=250kbps]; [RS232=1Mbps,
RS422/RS485=10Mbps].
ERP Support
The optional settings: [Enabled]; [Disabled].
This item should be set as [Disabled] if you wish to have all active wake-up
functions.
Case Open Detect
Use this item to detect if case have ever been opened. Show message in POST.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], system will detect if COPEN has been short or not (
refer to
JBAT
jumper setting for Case Open Detection
); if Pin 7-8 is short, system will
show Case Open Message during POST.
WatchDog Reset Timer
Use this item to enable or disable WDT reset function. When set as [Enabled], the
following sub-items shall appear:
WatchDog Reset Timer Value
User can select a value in the range of [10] to [255
] seconds when ‘
WatchDog
Reset Timer Unit
’ set as [Sec]; or in the range of [1] to [255] minutes when
‘
WatchDog Reset Timer Unit
’ set as [Min].
WatchDog Reset Timer Unit
The optional settings are: [Sec.]; [Min.].
WatchDog Wake-up Timer
This item support WDT wake-up.
The optional settings are: [Enabled]; [Disabled].