39
WatchDog Reset Timer Value
User can select a value in the range of [10] to [255] seconds when ‘
WatchDog
Reset Timer Unit
’ set as [Sec]; or in the range of [1] to [255] minutes when
‘
WatchDog Reset Timer Unit
’ set as [Min].
WatchDog Reset Timer Unit
The optional settings are: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power
supply. Use needs to select ‘AT or ATX Mode’ on MB jumper at first (refer to
JAT_ATX jumper setting Pin 1&2 of for ATX Mode & Pin 2&3 of AT Mode Select).
Case Open Detect
Use this item to detect case has already open or not, show message in POST.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], system will detect if COPEN has been short or not (refer
to COPEN jumper setting for Case Open Detection); if Pin 1&2 of COPEN are
short, system will show Case Open Message during POST
►
PC Health Status
Press [Enter] to view current hardware health status, make further settings in
‘
SmartFAN Configuration
’.
►
SmartFAN Configuration
Press [Enter] to make settings for SmartFan Configuration:
SmartFAN Configuration
CPUFAN1 Smart Mode
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
CPUFAN1 Full-Speed Temperature
Use this item to set CPUFAN1 full speed temperature. Fan will run at full speed
when above this pre-set temperature.
CPUFAN1 Full-Speed Duty
Use this item to set CPUFAN1 full-speed duty. Fan will run at full speed when