41
Spread Spectrum Disabled
Clock Control By Hardware
** Current Host Clock is 100 MHz **
HOST clock at next boot is 100 Mhz
** Current DRAM Clock is 100 MHz **
DRAM clock at next boot is 100 Mhz (HOST CLK)
Menu Level >
↑↓→←
Move Enter:Select Item +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
Auto Detect DIMM/PCI Clk
This item allows you to enable/disable auto detect DIMM/PCI Clock.
The settings are: Enabled, Disabled.
Clock Control
This item allows you to set the CPU Host Clock by Hardware (Jumper
S1
), or by Software
(BIOS)
Host clock at next boot is
When Clock Control setting By Software this item allows you to set CPU Host Clock step by
step from 100MHz to 166MHz, use Page Down/Page Up key can change the frequency to
approach over clocking.
DRAM clock at next boot is
This item allows you to set the DRAM clock synchronous as CPU Host Clock or
Asynchronous as Host clock *4/3 to approach your SDRAM specification.
3-12 Load Standard/Optimized Defaults
Load Standard Defaults
When you press <Enter> on this item, you get confirmation dialog box with a message similar
to:
Load Standard Defaults (Y/N)? N
Pressing <Y> loads the BIOS default values for the most stable, minimal-performance system
operations.
Load Optimized Defaults
When you press <Enter> on this item, you get a confirmation dialog box with a message
similar to:
Load Optimized Defaults (Y/N)? N
Pressing <Y> loads the default values that are factory settings for optimal performance
system operations.
3-13 Set Supervisor/User Password
You can set either supervisor or user password, or both of them. The differences are:
Supervisor password:
Can enter and change the options of the setup menus.
User password:
Can only enter but do not have the right to change the options of