14
(6) Parallel Port Connector (25-pin female): PARALLEL
Parallel Port connector is a 25-pin D-Subminiature Receptacle connector. The On-
board Parallel Port can be disabled through the BIOS SETUP. Please refer to Chapter 3
“INTEGRATED PERIPHERALS SETUP” section for more detail information.
(7)
Audio Line-In, Lin-Out, MIC Connector : J1
This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC, Surround, CEN/LEF
Line-out : (GREEN)
Audio output to Front speaker
Line-in : (BLUE)
Audio input to sound chip/ Rear speaker out
MIC : (PINK)
Microphone Connector/ Center/Subwoofer speaker out
(8) Serial Port COM1/COM2 : COM1/COM2
COM1 is the 9-pin D-Subminiature male connector. The On-board serial port can be
disabled through BIOS SETUP. Please refer to Chapter 3 “INTEGRATED PERIPHERALS
SETUP” section for more detail information.
(9) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy drives.
Floppy Drive Connector
Pin 1
FDD
(10) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s).
If you install two hard disks, you must configure the second drive to Slave mode by
setting its jumpers accordingly. Please refer to the documentation of your hard disk for
the jumper settings.
LAN
LINE-OUT
LINE-IN
COM1 COM2
USB1
MIC
PS/2 Mouse
PS/2 Keyboard
USB
