6
2-1 Hardware installation Steps
Before using your computer, you had better complete the following steps:
1.
Check motherboard setting
2.
Install CPU
3.
Install Memory
4.
Install Expansion cards
5.
Connect Ribbon cables, Panel wires, and power supply
6.
Setup BIOS
7.
Install software driver & utility
2-2 Checking Motherboard’s Jumper Setting
1. CPU Front Side Bus Frequency Setting (2x4-pin) : JP4
JP4
1-2 3-4 5-6 7-8
100/100 ON
OFF
OFF
OFF
100/133 OFF ON ON OFF
133/133 ON
ON
OFF
OFF
133/166 ON
OFF
ON
ON
CPU F.S.B. Frequency Setting
100/133
100/100
JP4
1
2
7
8
JP4
1
2
7
8
133/133
JP4
1
2
7
8
133/166
JP4
1
2
7
8
Note: CPU Front Side Bus Frequency also can setting step by step in BIOS SETUP,
please refer page
33
Miscellaneous Control in Host Clock at Next.
2. CMOS RAM Clear (3-pin) : JP6
A battery must be used to retain the motherboard configuration in CMOS RAM short 2-3
pins of JP6 to store the CMOS data.
To clear the CMOS, follow the procedure below:
1.
Turn off the system and unplug the AC power
2.
Remove ATX power cable from ATX power connector
3.
Locate JP6 and short pins 1-2 for a few seconds
4.
Return JP6 to its normal setting by shorting pins 2-3
5.
Connect ATX power cable back to ATX power connector
Note: When should clear CMOS
1.
Troubleshooting
2.
Forget password
