12
Pin 1
IDE2
Pin 1
IDE1
•
Two hard disks can be connected to each connector. The first HDD is referred to as the
“Master” and the second HDD is referred to as the “Slave”.
•
For performance issues, we strongly suggest you don’t install a CD-ROM or DVD-ROM
drive on the same IDE channel as a hard disk. Otherwise, the system performance on this
channel may drop.
2-6-2 Headers
(1) COM2 Serial Port Headers (9-pin) : COM2
This board has two serial port COM1 (Connector)/COM2(Headers), it come with cable
providing serial port COM1/COM2. The On-board serial port can be disabled through
BIOS SETUP. Please refer to Chapter 3 “INTEGRATED PERIPHERALS SETUP“ section
for more detail information.
COM2
Pin 1
Note: Orient the read marking on the
COM1/2 ribbon cable to pin 1
(2) Parallel Port Headers (25-pin Block): Parallel
The On-board Parallel Port can be disabled through the BIOS SETUP. Please refer to
Chapter 3 “INTEGRATED PERIPHERALS SETUP” section for more detail
information.
(2) Line-Out, MIC Header (9-pin): AUDIO
This header connect to Front Panel Line-out, MIC connector with cable.
Line-Out, MIC Headers
AUDIO
Pin 1
AUD
-
MIC
AUD
-
FPOUT
-
L
AUD
-
MIC
-
BIAS
AUD
-
FPOUT
-
R
HP
-
ON
AUD
-
GND
AUD
-
RET
-
L
AUD
-
RET
-
R
AUD
-
VCC
2
9
10
