16
(6)
VGA Connector (15-pin female): VGA
VGA
Connector is a 15-pin D-Subminiature Receptacle connector.
This connector is for connection Monitor and System to display.
(7)
LAN Port Connector: LAN
These connectors are standard RJ45 connector for Network supports 10/100 BASE-T transfer
rate.
(8)
Audio Connector: LINE-OUT, MIC
This Connector are 2 phone Jack for LINE-OUT, MIC.
Line-out :
Audio output to speaker
MIC :
Microphone Connector
(9) Floppy drive Connector (34-pin block): FDC1
This connector supports the provided floppy drive ribbon cable. After connecting
the single plug end to motherboard, connect the two plugs at other end to the
floppy drives.
Pin 1
Floppy Drive Connector
(10) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s).
If you install two hard disks, you must configure the second drive to Slave mode by
setting its jumpers accordingly. Please refer to the documentation of your hard disk for
the jumper settings.
(11) Secondary IDE Connector (40-pin block): IDE2
This connector connects to the next set of Master and Slave hard disks. Follow the
same procedure described for the primary IDE connector. You may also configure two
COM1
LINE-OUT
MIC
PS/2
MOUSE
PS/2
Keyboard
USB
VGA
LAN
IEEE 1394
