
4. Unpacking the box
A. Blower components
Each MJet V2 STD Kit contains the following items:
-
MJet V2 main unit
-
Machine mount
-
Hose Assembly
-
Quick Connect
-
Air clamp/air block (varying related to order)
-
Cable Seals Kit (varying related to order)
8
5. Set up the blower
This manual contains setup and operating instructions for the MJet V2.
Do not connect power supply until setup is complete.
A. Determine cable size
• Determine cable size to be installed.
B. Select cable seal & pipe
• Choose the correct cable seal and air block for the particular application according to duct and cable
size.
C. Install cable seal & cable in air block
• Install the appropriate cable seal on the cable. Make sure orientation of seal on cable is correct so
that it will seat in the air block properly. The seal lip of the cable seal should be facing the duct end.
• Once the cable seal is positioned properly on the cable, install the cable seal in the bottom half
of the appropriate air block.
D. Install duct
• Place cable seal over the cable.
• Position the duct properly in the bottom half of the air block.
• Ensure there is adequate length of duct available to avoid unnecessary strain on the duct.
• Place cable into duct, place cable and seal into air block.
• Once the duct is in place, secure the configuration by installing the top half of the air block and
pressing firmly together.
E. Install duct & cable in blower
• Loosen the knob on the air block assembly. Open the air block cover. Insert the duct into the
air block as shown. Close air block cover and hand tighten knob to secure.