Jetter JetWeb JX2-CNT1, User Manual

Page: 19 / 100

JX2-CNT1 2 Introduction
Jetter AG 19
2 Introduction
This manual contains important information on how to transport, erect, install,
operate, maintain and repair the non-intelligent expansion module JX2-CNT1 with
firmware version 3.02 or higher.
2.1 Product Description
The JX2-CNT1 module is for position capturing and for counting events. In the case
of position capturing signals from an incremental encoder (via dual-channel counter)
or an absolute encoder (SSI) are evaluated. The single-channel counter is for
counting events.
The position obtained from position capturing can be evaluated in the application
program or be sent via system bus as set position (master position) to an axis
controller by Jetter AG. The single-channel counter is used e.g. as workpiece
counter.
2.2 Ordering Information
Jetter system bus connecting cable:
Designation Description Article No.
JX2-CNT1 Counter module: 1 dual-channel counter (1
MHz) + 1 single-channel counter (10 kHz) or 1
SSI absolute e 1 single-channel
counter 10000139
Jetter system
bus cable Cable assy # 530 + length:
0.2 m; 0.5 m; 1.0 m; 1,5 m; 3 m; 4 m; 5 m
(other lengths on request) see table
below
Length 0.2 m: Cable assy # 530 0.2 m Article # 10309001
Length 0.5 m: Cable assy # 530 0.5 m Article # 10309002
Length 1.0 m: Cable assy # 530 1.0 m Article # 10309003
Length 1.5 m: Cable assy # 530 1.5 m Article # 10309004
Length 2.0 m: Cable assy # 530 2.0 m Article # 10309006
Length 2.5 m: Cable assy # 530 2.5 m Article # 10309016
Length 3.0 m: Cable assy # 530 3.0 m Article # 10309015
Length 4.0 m: Cable assy # 530 4.0 m Article # 10309007
Length 5.0 m: Cable assy # 530 5.0 m Article # 10309008