Jetter JetMove D203, User Manual

Page: 11 / 142

JetMove D203 1.1 General Safety Instructions
Jetter AG 11
1 Safety instructions
1.1 General Safety Instructions
The digital servo amplifier JetMove D203 meets the applicable safety regulations and
standards. Special emphasis was given to the safety of the users.
Further, the user should adhere to the following regulations:
• relevant accident prevention regulations;
• accepted safety rules;
• EC guidelines and other country-specific regulations.
1.1.1 Intended Use
Usage according to the intended conditions of use includes operation in accordance
with these operating instructions.
Operate the digital servo amplifier JetMove D203 only in a closed control cab-
inet and within the range of the specified values, see Chapter 5 "Technical Da-
ta", page 37.
Do not apply a voltage to the digital servo amplifier JetMove D203 that is higher
than the specified operating voltage.
The operating voltage voltage of the JM-D203 is 195 ... 265 VAC (one-phase). Thus,
the digital servo amplifier is subject to the EU Low Voltage Directive.
The JetMove D203 servo amplifier has been designed to drive 3-phase brush-
less synchronous servo motors in the following modes: speed control, torque
control and/or position control. The winding insulation of the motors must be
higher than, or at least equal to, the DC link voltage supplied by the servo am-
plifier.
The digital servo amplifier JetMove D203 is used to drive machinery, such as con-
veyors, production machines, and handling machines.
1.1.2 Usage other than intended
This digital servo amplifier must not be used in technical systems which to a
high degree have to be fail-safe, e.g. ropeways and airplanes.
Do not use the integrated braking circuit in applications, where, in case of
braking circuit failure, safety hazards can occur.
The JetMove D203 is no safety-related part as per Machinery Directive 2006/42/
EC. Therefore, using this servo amplifier for safety-relevant applications as re-
gards safety of persons is neither suitable nor permitted.
An exception to this is the STO function of servo amplifiers with option- S1, see
Chapter 11 "Option -S1: STO", page 91.