Jetter JetMove 225-480, User Manual, Page: 39 / 126

JetMove 225-480 5.1 Electrical Specifications
Jetter AG 39
Digital inputs
– Enable (E),
– Reference switch (R);
– Limit switch RH (L+), and
– Limit switch LH (L+);
– Input (Inp) DC 20 V ... 30 V related to the ground
potential of voltage supply of processor
logics, with an input current of 7.5 mA max.
each.
See "Digital Inputs, Logic Power Supply"
on page 71.
Braking relay V
max
= DC 30 V
I
max
= DC 2 A
Contact: Type NO
connected to BR1 and BR2 on X10
The lines may only be connected to
devices that are related to the same
potential as the power supply of the
controller logic.
Can be switched by the control program of
PLC or by operating system of JetMove
225-480 together with software enable.
Digital outputs
Number of outputs
Output type
Rated voltage
Voltage range
Load current
Electrical isolation
Protective circuits
Protection against inductive loads
Signal voltage ON
4
Transistor pnp type
24 V
20 ... 30 V related to the ground potential of
voltage supply of processor logics
max. 0.5 A / output
none
Short-circuit, overload, overvoltage,
overtemperature protection
Yes
Type V
supply
- 1.5 V
Power dissipation P
v
Output stage: 250 W max.
Logic circuit: 20 W max.
Electrical Specifications