Jetter JetMove 225-480, User Manual, Page: 71 / 126

JetMove 225-480 7.7 Digital Inputs, Logic Power Supply
Jetter AG 71
7.7 Digital Inputs, Logic Power Supply
Specification of terminal X10
• 10-pin spring tension terminal (type ZEC 1,0/10-ST-3,5)
• Diameter of the cable apt for connecting: 0.2 ... 1 mm
2
(AWG 24 ... AWG 16)
with bootlace ferrules in a plastic sleeve: 0.25 ... 0.75 mm
2
(AWG 24 ... AWG 18)
• Bladed screw-driver: 0.4 x 2.5 mm
Digital Inputs, Logic Power Supply
Wiring
Terminal
X10 at the
Amplifier
Signal Function Specifications
ENABLE Hardware
enable for
the power
supply of the
motor (input) • A high signal at this
input is necessary for
the motor to be supplied
(the power supply has to
be connected before
software enable).
• A low signal de-
energizes the motor
immediately.
• DC 24 V
• 7.5 mA max.
• Operating point:
< 6 V low, > 15 V
high
REF Reference
switch (input) • Depending on the
parameter setting, this
input is used for
referencing.
• DC 24 V
• 7.5 mA max.
• Operating point:
< 6 V low, > 15 V
high
NC or NO contact
LIMIT + Positive limit
switch (input) • Depending on the
parameter setting, this
input is used as a
positive limit switch.
• DC 24 V
• 7.5 mA max.
• Operating point:
< 6 V low, > 15 V
high
NC or NO contact
NC contact
recommended
LIMIT - Negative
limit switch
(input) • Depending on the
parameter setting, this
input is used as a
negative limit switch.
• DC 24 V
• 7.5 mA max.
• Operating point:
< 6 V low, > 15 V
high
NC or NO contact
NC contact
recommended