Jetter JC-120MC, User Manual

Page: 14 / 634

14 Jetter AG
1 Safety instructions
Basic safety instructions
This device complies with the valid safety regulations and standards.
Jetter AG attaches great importance to the safety of the users.
Of course, the user should adhere to the following regulations:
 Relevant accident prevention regulations

Accepted safety rules
 EC guidelines and other country-specific regulations
Usage according to the intended conditions of use implies operation in
accordance with this User Manual.
The controller JC-120MC is used to control machinery, such as conveyors,
production machines, and handling machines.
Operate the controller JC-120MC only within the limits and conditions set forth
in the technical specifications. The operating voltage of the controller
JC-120MC is classified as SELV (Safety Extra Low Voltage). Therefore, the
JC-120MC controller is not subject to the EU Low Voltage Directive.
The device must not be used in technical systems which to a high degree
have to be fail-safe.
The JC-120MC is no safety-related part as per Machinery Directive
2006/42/EC. This device is not qualified for safety-relevant applications and
must, therefore, NOT be used to protect persons.
If you intend to operate the device at ambient conditions not being in
conformity with the permitted operating conditions, please contact Jetter AG
beforehand.
Depending on the life cycle of the product, the persons involved must possess
different qualifications. These qualifications are required to ensure proper
handling of the device in the corresponding life cycle.
Product life cycle Minimum qualification
Transport/storage:
Trained and instructed personnel with knowledge in
handling electrostatic sensitive components.
Mounting/installation:
Specialized personnel with training in electrical
engineering, such as industrial electronics technician.
Commissioning/
programming:
Trained and instructed experts with profound
knowledge of, and experience with, electrical/drive
engineering, such as electronics engineer for
automation technology.
Operation:
Trained, instructed and assigned personnel with
knowledge in operating electronic devices.
Decommissioning/
disposal:
Specialized personnel with training in electrical
engineering, such as industrial electronics technician.
For safety reasons, no modifications and changes to the device and its
functions are permitted.
Any modifications to the device not expressly authorized by Jetter AG will
Introduction
Intended conditions of
use
Usage other than
intended
Personnel qualification
Modifications and
alterations to the module