JETSTOR SAS 760J/JD Hardware Installation Guide
Page 32 of 71
5.1
POWER-UP PROCEDURE FOR A SINGLE JETSTOR SAS 760J/JD
SYSTEM
1.
Turn on both PCMs (Power and Cooling Modules) using the power switches on
the back of the enclosure.
2.
Wait approximately 1 minute for the drives to all become ready.
3.
Power on and boot the host computer.
5.2
POWER-UP PROCEDURE FOR A MULTIPLE JETSTOR SAS 760J/JD
SYSTEM
1.
For systems with expansion enclosures attached, the enclosure last in the chain
should be powered up first, followed by the other enclosures with the master unit
being turned on last. The power up order is critical for each of the expansion
boxes to properly be seen by the previous unit in the chain.
2.
Power up the JETSTOR SAS 760J/JD systems by pressing the power switches on
the rear of the enclosures located on the PCMs (Power and Cooling Modules).
3.
Wait approximately 1 minute for the drives to all become ready.
4.
Power on and boot the host computers.
5.3
POWER-DOWN PROCEDURE FOR A SINGLE JETSTOR SAS 760J/JD
SYSTEM.
1.
Power down the host computer.
2.
Power down the JETSTOR SAS 760J/JD by turning off the switches on the PCMs
(Power and Cooling Modules)
5.4
POWER-DOWN PROCEDURE FOR A MULTIPLE JETSTOR SAS
760J/JD SYSTEM.
1.
Power down the host computer(s).
2.
Power down the master JETSTOR SAS 760J/JD by turning off the switches on the
PCMs.
