Jetson V6-XL, Manual

Page: 13 / 20

13
PROTECTION FUNCTION
If there is a system error or improper operation during usage, the V6-XL may
give you a prompt. This will only occur under certain conditions, such as:
• Surface angle exceeds 20° (If the angle is more than 35° the motor will shut
off after 15 seconds).
• Maximum speed is reached.
• Motor is overheating or overcharging.
• System enters overcharging protection mode (the green indicator will light
up).
• A wheel is blocked (the V6-XL will shut down after 2 seconds).
• Battery is low but still being used (the V6-XL will turn the motor off after 15
seconds).
• Balancing in a neutral position for over 30 seconds.
HOW TO RECALIBRATE
When the V6-XL experiences an error, the running indicator light will turn red.
That means it will not operate until it is properly recalibrated. Please do not try
getting on the unit until the error has been fixed. To recalibrate, follow these
steps:
1. Put the hoverboard on a flat, level surface, with the pads facing up.
2. Press and hold the Power Button for about 5 seconds until the lights on the
V6-XL flash, and you are notified of a successful calibration.
3. Turn it OFF and then ON again to restart the V6-XL. That completes the
recalibration, and is now ready for use.
STORAGE
• If you plan on storing the V6-XL for a substantial period of time, please make
sure you fully charge the battery before storing. The battery should be fully
charged once a month after this.
• You should bring the V6-XL into a warm environment (above 50 degrees
Fahrenheit) for charging.
• To protect against dust, cover the V6-XL.
• Store the V6-XL indoors, in a dry place and at a suitable temperature.
• Do not leave the V6-XL plugged into the charger for long periods of time.