Jetson Helio X, Manual

Page: 14 / 24

12
1.2
Assembly
• LOOSEN AND REMOVE THE BOLT AND NUT THAT ARE PRE-ATTACHED IN THE BASE OF THE HANDLEBAR WITH THE
SCREWDRIVER BIT OF THE 2-BIT TOOL. SET ASIDE.
• PUSH THE HANDLEBAR DOWN FIRMLY ONTO THE STEM UNTIL THE PRE-DRILLED HOLES IN THE HANDLEBAR ALIGN WITH
THE PRE-DRILLED HOLES IN THE STEM.
• INSERT THE BOLT THROUGH ALL FOUR HOLES AND TWIST THE NUT ONTO THE END. TIGHTEN WITH THE 2-BIT TOOL.
IMPORTANT: PLACE THE NUT ON THE RIGHT SIDE WHEN FACING THE FRONT OF THE HELIO X.
BOLT NUT