Jetson E-PUNK, Manual, Page: 7 / 16

7
TURNING ON AND OFF
Press the Power Button to turn the E-Punk on. To turn the E-Punk off,
press the Power Button again.
CONNECTING THE REMOTE CONTROL
To connect the Remote Control, first ensure that the Remote Power
Switch is turned to Off, and that the E-Punk is turned off. Set the speed
switch, located in the Remote Control above the batteries, to slow. Set
the Direction Switch to Reverse.
Turn the E-Punk on, and press the Binding Button. Then, pull the
Accelerate/Brake Switch down to “Stop” and hold for 3 seconds. Turn
the Remote Power Switch to On and wait a few seconds. When the
Indicator Light flashes and the Power Button lights green, you have
successfully connected the Remote Control to the E-Punk.
CONTROLS
Push the Accelerate/ Brake Switch forward to accelerate, and push it
back to brake.
Reverse Mode - Push the Direction Switch to change driving direction.
Now, when you push the Accelerate/ Brake Switch forward it will
accelerate in reverse. Push the button back to brake.
PLEASE NOTE: Always accelerate and brake in small increments. Learn
to use the brake function before riding your E-Punk in public places.
Become comfortable with the power and speed of the brake before
attempting to ride for long periods of time.
OPERATING THE E-PUNK
SAFE RIDING
Helmet: Most serious injuries that occur while riding are head injuries.
This could be prevented by wearing a helmet.
Elbow and Knee Pads: For added protection, always wear elbow and
knee pads when riding your E-Punk, to prevent any serious injuries.