Installation:
Fitting the Gas Grate
1. Check unit is suitable for intended gas supply.
2. The position of the gas control and inlet is on the
right hand side. A regulator is supplied when fitting to
natural gas. A gas cock must be fitted prior to the
burner to enable the unit to be removed for servicing.
(It is recommended that the fireplace and chimney be
cleaned prior to fitting the gas unit).
3. In an existing fireplace or Jetmaster firebox (if being
used), drill a 15mm hole through the right hand side of
the fireplace (as you face it) at a point of 85mm from
the base and 85mm from the front face.
4. Cut and debur both ends of pipe. Fit the end to
the gas supply point and turn on for approximately
5 seconds to clear the pipe of any dirt or grit. Fit the
other end to the gasunit.
5. The regulator supplied and attached to the
appliance is for natural gas.
6. Turn on the gas and check all connections for leaks
using soapy water for approved method. Fix any leaks.
7. This appliance is approved for use only on Natural
Gas and must not be converted to any other gas.
Adjusting Pressure, Pilot
and Low Fire
1. All settings are set to operate at appropriate
pressures (see data plate). Test point is located on gas
valve.
2. Check low fire if adjusted correctly.
Lighting Instructions
PILOT IGNITION
1. To turn burner on stop cock needs to be in
horizontal position.
(FIGURE 1)
2. Ensure left hand button on control is fully extended
before igniting
(FIGURE 2)
(a large flame should be showing
in the window).
3. Depress right hand button
(FIGURE 3)
(which is the
pilot) in and hold whilst either lighting manually with
lighted match or depressing piezo. Lighter needs to be
placed at pilot until burning. Hold button in for
approximately 20 seconds then release. If pilot goes
out repeat step 3.
BURNER IGNITION
1. The button on the right
(FIGURE 4)
controls the gas to
the burner and the button on the left
(FIGURE 5)
controls
either high or low settings.
2. With pilot only burning right hand button will be
fully depressed. Push right hand button in and release
button to a fully extended position and main burner
will ignite.
3. Depress left hand button
(FIGURE 6)
for low setting.
Small flame will appear in left hand window.
TURNING MAIN BURNER OFF
1. Depress right hand button
(FIGURE 7)
in from fully
extended position to off position.
TURNING PILOT TO OFF POSITION
1. Turn stop cock from horizontal to vertical
(FIGURE 1)
to turn pilot off.
Installation instructions Jetmaster Mark 4 Gas Log
(FIGURE 1)
(FIGURE 2)
(FIGURE 3)
(FIGURE 4)
(FIGURE 5)
(FIGURE 6)
(FIGURE 4)
(FIGURE 7)
