MVario2
The
sensor can only be configured
if the ECS-in throttle channel
(pulse) is not connected after connecting the power supply to the
sensor. Once a pulse is connected to the ESC-in, the sensor can no
longer be set until its power supply is reset. Settings can be made by
the Jetibox or DC/DS transmitter (in the "device explorer" menu).
The measured
data can be seen
if the sensor is in the "Idle" or
"Done" status. The sensor save the data from the last measurement
and can be read again after connecting the power supply.
In the
Idle status, you can view the data from the last measurement.
Measurement data means the maximum relative height reached
during motor run and 10s after that and 10 relative altitude values
saved after 1s of motor run.
The sensor can be in the
Ready
status if a throttle control pulse is
connected to the ESC-in input and the pulse value is less than the
set level for motor shutdown (default setting 1.1ms).
The Sensor will be in the
Running
status if the throttle control pulse
exceeds the motor shutdown pulse level. After stopping the motor
the sensor goes from the
Running
status to the
Measuring
status
and the sensor evaluates the measurement for another 10s.
EN
