JetCat P100-RX, Manual, Page: 32 / 54

PAGE 32 of 54
Table 2
Code Value Explanation
1 R/C Off AUX switched to Off position or throttle stick and throttle trim moved to the
minimum position.
2 OverTemp Turbine running over temperature. Exceeded high temperature parameter
and time out.
3 IgnTimOut Turbine did not ignite within programmed time interval.
4 AccTimOut Turbine achieved ignition, but did not accelerate within programmed time
interval.
5 Acc.Slow Turbine achieved ignition, but acceleration was less than the programmed
value, during startup.
6 Over-RPM Turbine exceeded the maximum RPM, by 5% and a delay of 0.5 seconds.
7 Low-RPM Turbine running under the minimum RPM, by 10% and a delay of 3 seconds.
Usually triggered by a flame out.
8 BattryLow
Battery pack is dead. Cell voltage is < 1.0V.
9 Auto-Off Turbine shut down via the AutoOff sequence, using the AUX channel.
10 LowTemp EGT dropped below the minimum value. A dislodged EGT sensor can trigger
this shut down.
11 HiTempOff EGT exceeded the maximum range (~950 °C).
12 GlowPlug! Defective kero/glow plug.
13 WatchDog ECU processor was locked out usually from static discharge or voltage spike
in power supply.
14 FailSafe Turbine was shut down from a failsafe timeout condition.
15 ManualOff Turbine was shut off by using the GSU.
16 PowerFail The power failed to the ECU when the turbine was running. This will occur if
the power was lost because of a defective battery, connection or if the switch
is turned off before the engine is shut-down.
Note: If this state is displayed the Info, Min/Max and Statistics menus
retain information from the previous run.
17 TempSensor
Fail
EGT sensor failed.
Note: This could happen only during startup.
18 Wrong Pmp Wrong pump type, see pump configuration in the advanced section of the
manual.
19 No Pump There is either no pump connected or the pump cable is defective.
20 Over Curr The electrical current to the engine is too high.

Starter may be jammed

Kero/glow plug is short circuited