CLEANING STATION
SAFETY INFORMATION
3
Electrical Safety
• This equipment is designed to be hard
wired to a fused supply. Check that the
correct wire gauge is used and that
the correct voltage is available before
connection. Refer to the Cleaning Station
rating plate for full details – this is located
on the side of the Touch Switch Box
• The Cleaning Station can be fitted with
a speed controller, which allows for the
speed to be changed
• Any attempt to change the timer switch
settings will invalidate the warranty
• The Cleaning Station should be
connected to an electrical supply that is
surge protected and in compliance with
local codes
• The appliance must be earthed
• Always shut off the supply power and
isolate the Cleaning Station before
performing any maintenance operations
General Safety
• The Cleaning Station is supplied with a
touch activated time switch, mounted in a
weatherproof enclosure sealed to an IP55
rating
• To operate, press the ‘Touch’ button. The
Cleaning Station will run for 30 seconds
– if you require less time, simply press
the ‘Touch’ button again, and the unit will
turn off
• If an anti-static unit has been fitted, a
second switch is located on the front of
the Cleaning Station – the switch must
be on ‘I’ for the anti-static pack to
work correctly
Wall Mounted Units
• The On/Off switch is located behind the
carrying handle on the main body. Press
‘I’ to turn the unit On, and ‘O’ to turn off
• If an anti-static unit has been fitted, a
second switch is located on the front of
the unit – the switch must be on ‘I’ for the
anti-static pack to work correctly
• Always ensure that the portable Cleaning
Station stands level on the four plastic
feet provided
• The Cleaning Station can be fitted with
a speed controller, which allows for the
speed to be changed
Portable Units
• These units are not designed for
continuous use
• The Cleaning Station is suitable for safe
area installation only and
must not be
used in ATEX zones or near the presence
of explosive substances
