4
Before Assembly
1. Unpack the taper attachment from the box.
2. Disassemble the taper attachment and clean
thoroughly with a mild solvent.
3. Lightly oil all surfaces with machine tool oil.
Assembly
1. Remove two hex bolts (A, Figure 1) from the
bracket.
2. Remove the two cross feed nuts (B, Figure
1) while holding the cross feed handle.
3. Remove the outer bearing and block (C,
Figure 1).
4. Remove the inner bearing assembly from
behind the block. (Figure 2).
5. Attach the taper attachment main body to
the lathe bed with four M10x50 hex socket
cap screws and four washers (A, Figure 3).
Don’t tighten the screws all the way at this
time.
6. Install the inner bearing and feed block
leaving it loose for adjustment (A, Figure 4).
Fasten the set collar, on the feed block, with
a hex socket cap screw. Install the taper
slide rest leaving it loose for adjustment (B,
Figure 4).
Figure 1
Figure 2
Figure 3
Figure 4
