9
7.0
Setup and assembly
Read and understand all
assembly
instructions
before
attempting
assembly. Saw must remain unplugged from
power source during assembly procedures.
7.1
Shipping contents
Refer to Figure 7-1.
1 Scroll saw (not shown)
4 Leveling feet with hex nuts
4 Rubber washers – (HP5)
3 Lower blade holders (one installed)
5 Blades, reverse skip tooth (one installed)
1 Operator’s manual (not shown)
1 Product registration card (not shown)
Figure 7-1: contents (not to scale)
Stand (Optional Accessory)
Refer to Figure 7-7, or sect. 15.4.1.
2 Short top braces – (#3)
2 Long top braces – (#4)
2 Short bottom braces – (#7)
2 Long bottom braces – (#8)
4 Legs – (#5)
4 Leg extensions – (#10)
1 Hardware package (see Figure 7-2); contains:
4 Hex cap screws 5/16x1 – (HP1)
24 Carriage bolts 5/16x1/2 – (HP2)
32 Flat washers 5/16 – (HP3)
28 Hex nuts 5/16 – (HP4)
7.2
Tools required for assembly
14mm open-end wrench (for foot pads)
3mm hex wrench (for blade guide)
7.2.1
Tools required for optional
accessories
12mm wrench (for optional stand)
#2 Cross-point screwdriver (for optional blade
rack)
Note: Additional tools may be needed for
adjustments and general maintenance.
Figure 7-2: hardware package JWSS22B-SHK
7.3
Unpacking and cleanup
1. Remove all contents from shipping carton.
Remove protective coating from the table using
a soft cloth moistened with a solvent. (Do
not
use acetone, gasoline or lacquer thinner for this
purpose, as these will damage painted and
plastic parts.)
2. Inspect contents for shipping damage or
missing parts. Report any damage or part
shortages to your distributor. (Note: Check saw
for any pre-installed parts before reporting part
shortage.)
7.4
Transporting saw
Do NOT lift scroll saw beneath
arm (Figure 7-3) which may result in damage to
linkage system. Always lift using motor and
edge of table (Figure 7-4).
Figure 7-3: INCORRECT lifting
Figure 7-4: correct lifting
