8. If replacing a pulley, loosen both set screws (E), and
slide pulley off spindle.
9. Install new pulley, loosely securing the two set screws.
Make sure pulley is oriented properly and key is
inserted properly in spindle groove.
10. Slide spindle back into place.
11. Reinstall handwheel (C) and tighten set screws.
12. Align new pulley then tighten both set screws securely
on pulley.
13. Loosen pivot lock handle (A) and lower motor using
tension handle (B). Re-tighten pivot lock handle.
14. Disengage spindle lock.
Fig 35
8.3 Changing belt and bearings
Changing belt and bearings can be a difficult task. Remove
headstock and take into a repair station for servicing.
9. Trouble shooting
Motor doesn’t start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
*Overload detected on AC-drive unit-
wait and restart machine; chose low speed range belt setting
(40-1200 rpm) for better torque.
Machine vibrates excessively
*
Stand on uneven floor-
adjust stand for even support.
*Workpiece is not properly centred
*The speed is too high
*Workpiece is not properly centred-
*The speed is too high-
Tailstock moves
*Cam lock nut needs adjusting-
Tighten cam lock nut.
*Bed and tailstock mating surfaces greasy or oily-
Remove tailstock and clean surfaces
*Excessive pressure applied-
Slide tailstock to right side of lathe against stop (N, Fig 10).
Move headstock into position and then apply pressure.
10. Environmental protection
Protect the environment.
Your appliance contains valuable materials which can be
recovered or recycled. Please leave it at a specialized
institution.
11. Available accessories
Stock number
719401
Bed extension 508mm with tool post extension
Stock number 719001
Tailstock swing away
Stock number 719002
Guard
Stock number 708331
Live centre MT2
Stock number 708343K
Drill chuck 13 mm, with tapered mandrel MT-2
Stock number 709911
Face plate 75mm, M33x3,5
Stock number 709942
Four toothed spur centre MT-2
