8
WARNING
Read and understand the entire contents of
this manual before attempting assembly or
operation!
Failure to comply may cause serious injury!
Contents of the Shipping Containers
1. Lathe
1. Tailstock
1. Headstock
1. Tool Rest Body
1. Tool
Basket
1. Guard
Assembly
1. Accessory
Package
1. Owner’s Manual & Warranty Card
Accessory Package Box
1. Live
Center
1. Rod for Live Center
1. Spur
Center
1. Index
Pin
1. Face
Plate
1. Rod for Face Plate
1. Knockout Rod Headstock
1. Tool
Rest
4. Adjustable
Feet
Tool Basket Bracket Hardware
2. Hex Sckt Cp Screws 5/16”-18 x 1-1/2”
4. Flat
Washers
5/16”
2. Set Screws 1/4”-20 x 1/4”
3. Hex Nuts 5/16”
1. Set Screw 5/16”-18 x 5/8”
Unpacking and Clean-Up
1. Remove the shipping container. Do not
discard any shipping material until the lathe
is set up and running properly.
2. Remove hex cap bolts from skid bottom and
move the lathe off the skid and into position.
3. Clean all rust protected surfaces with a
cleaner degreaser. Clean thoroughly under
the headstock, tailstock and tool rest body.
Assembly
1. Secure tool rest (A, Fig. 1) to tool rest body
(B, Fig. 1) by tightening handle (C, Fig. 1).
2. Slide the tailstock and tool rest to the
headstock end of the lathe bed. See
“Controls and Features” section of this
manual on how to move the tailstock and
tool rest.
Contents of Accessory Package
Summary of Contents for JWL-1642EVS
Page 22: ...22 Stand and Bed Assembly...
Page 24: ...24 Headstock Assembly...
Page 27: ...27 Wiring Diagram...