7
6.0
Assembly
6.1
Base and column assembly
Refer to Figure 3:
1. Place
base
(D) on a level floor.
2. Place
column assembly
(E) on
base
(D) and align
holes in column support with holes in base.
3. Using a 5/8-in wrench, secure
column
(E) with
four M10 x 25
hex cap screws
(N) to the base.
6.2
Table and rack
Refer to Figure 4:
Note: If table arm/support assembly (C) and rack (E
3
)
are already installed on column (E), proceed to step 4.
Otherwise, begin with step 1.
1. Remove
rack ring
(E
1
) and
rack
(E
3
) from
column
(E).
Note which end of the rack is up. It must be
reinstalled later with the same side up.
2. Place
rack
(E
3
) inside
table
support
(C) such that
the teeth of the
rack
(E
3
) mesh with the pinion
gear on the end of the table crank handle
shaft
(C
1
).
3. Slide table arm/support
assembly
(C) together
with the
rack
(E
3
) onto the
column
(E) as shown.
4. Place
rack ring
(E
1
) onto
column
(E), sliding it
down so it rests against
rack
(E
3
) as shown, and
tighten
setscrew
(E
2
) with a 3mm hex wrench
(provided).
5. Place
table
(B) onto
table arm
(C), positioning it
as shown in Figure 4. Secure table with
lock
handle
(K).
6. Secure table extension (B
1
) with two
table
extension lock knob
s (Q).
6.3
Table height adjust and lock
handles
Refer to Figure 4:
1. Loosen the
setscrew
(R
1
) on the table
height
adjust handle
(R).
2. Slide
the
handle
(R) onto the table bracket
shaft
(C
1
).
3. Turn
the
handle
(R) until the
setscrew
(R
1
) is on
the flat section of the
shaft
(C
1
) and tighten the
setscrew
(R
1
) with a 3mm hex wrench to secure
the handle.
4. Thread
the
column lock
handle
(K) into the back
side of the
table bracket
(C) opposite the
height
adjust handle
(R).
Figure 3
Figure 4
