Jet JTAS-10XL, Operating Instructions And Parts Manual

Page: 8 / 36

8
Handwheel Assembly
•
Hardware: Handle & Hand Wheel, Lock Knob
•
Tool: 3mm Hex Wrench
1. Line up the key on the shaft with the key
way in the handwheel (A, Fig. 4) and slide
the handwheel onto the shaft.
2. Tighten the set screw on the handwheel hub
securely to hold in place.
3. Install center lock knob (B, Fig. 4) by
inserting into center hole in the shaft and
threading in a clockwise direction.
Blade Guard Assembly
•
Hardware: Blade Guard Assembly, Blade
Guard Mounting Bracket Assembly, Blade Guard
Wrench w/Cable and M16 Lock Washer
•
Tools: 12mm Wrench, 17mm Wrench or
Adjustable Wrench, 4mm Hex Wrench
1. Place the closed loop end of the cable (A,
Fig. 5) with the attached blade guard wrench
over the blade guard shaft.
2. Place a 5/8” lock washer (B, Fig. 5) onto the
threaded portion of the blade guard shaft.
3. Thread blade guard shaft into rear trunnion
through opening at rear of saw.
4. Tighten blade guard shaft. The blade guard
post has a flat detent to accommodate a
wrench.
5. Place upper and lower bracket assembly in
the upright position and snug two set screws
(C, Fig. 5) just enough to hold in place. Do
not tighten firmly at this time.
6. Insert front tab of blade guard assembly
through insert opening in the table. Loosen
the hex cap screw (A, Fig. 6) already
installed at the factory and insert the front
tab of the blade guard. The tab is held in
place between the flat washer and bracket.
Finger tighten only at this time.
7. Hold rear tab of blade guard assembly to
the upper blade guard bracket with two hex
cap bolts (B, Fig. 6). Finger tighten only at
this time.
8. A blade will need to be installed before final
adjustment can be made.